BCSGN - R-1007 SILICONE DISPERSION

  • MSDS: BCSGN
  • Manufacturer: MCGHAN NUSIL CORP
  • Product Name: R-1007 SILICONE DISPERSION
  • National Stock Number: 6810-00N009371
Product Identification

Product ID:R-1007 SILICONE DISPERSION
MSDS Date:12/11/1985
FSC:6810
NIIN:00N009371
MSDS Number: BCSGN

Responsible Party
MCGHAN NUSIL CORPORATION
1150 MARK AVENUE
CARPINTERIA, CA 93013

Emergency Phone: 805-684-8780

Info Phone: 805-684-8780

Preparer: D.J. PETRAITIS

Cage: 5U206

Contractor
NUSIL TECHNOLOGY
CARPINTERIA, CA 93013-2906 US

Telephone: 805-684-2365

Cage: 5U206

Ingredients

NAPHTHA (PETROLEUM SPIRITS OR BENZIN)

CAS: 8030-30-6

RTECS: SE7555000

Fraction By Weight: 30%

OSHA PEL 100 PPM

Hazards

Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:MAY CAUSE
HEADACHE,DIZZINESS,NAUSEA.SEVERE OVEREXPOSURE MAY CAUSE
UNCONSCIOUSNESS AND DEATH.CHRONIC:UNKNOWN.
Explanation of Carcinogenicity:NA
Effects of Overexposure:MAY CAUSE HEADACHE,DIZZINESS,NAUSEA,SEVERE
OVEREXPOSURE MAY CAUSE UNCONSCIOUSNESS AND DEATH.
Medical Cond Aggravated by Exposure:UNKNOWN-MFG.

First Aid

First Aid:INHALE:RMV TO FRESH AIR,IF BREATHING STOPS,GIVE ARTIFICIAL
RESPIRATION.O*2 MAY BE USED.GET MED ATTENTION.EYE:FLUSH WITH H*2O
FOR 15 MIN,GET MED ATTENTION.SKIN:WASH AFFECTED AREA WITH
SOAP&H*2O.REMOVE AND DISCARD CONTAM CLOTHING.GET MED
ATTENTION.INGEST:GET MEDICAL ATTENTION.

Fire Fighting

Flash Point Method:TCC
Flash Point:48F/8.8C
Lower Limits:1.0
Upper Limits:6.0
Extinguishing Media:FOAM,DRY CHEMICAL,CO*2.
Fire Fighting Procedures:SCBA SHOULD BE USED IN CONFINED AREAS.A
STRAIGHT STREAM SHOULD BE AVOIDED.
Unusual Fire/Explosion Hazard:A VAPOR ACCUMULATION COULD FLASH IF
IGNITED.INCOMPLETE COMBUSTION WILL PRODUCE CO AND OTHER TOXIC
SUBSTANCES. AUTOIGNITION TEMP 505F/262.7C.

Accidental Release

Spill Release Procedures:SPILLS SHOULD BE CONTAINED. LARGE SPILLS
REMOVED BY VACUUM, SMALLER SPILLS MAY BE SOAKED UP WITH ABSORBANT.

Handling

Handling and Storage Precautions:KEEP AWAY FROM HEAT,FLAMES AND OTHER
IGNITION SOURCES.

Exposure Controls

Respiratory Protection:WHEN VAPOR OR MIST EXCEEDS STANDARDS USE
NIOSH/MSHA APPROVED RESPIRATOR OR SCBA.
Ventilation:USE ADEQUATE VENTILATION TO KEEP VAPORS BELOW STANDARDS.
Protective Gloves:SOLVENT RESISTANT GLOVES.
Eye Protection:SAFETY GOGGLES.
Other Protective Equipment:EYE WASH AND SAFETY SHOWER IN WORK AREAS.
Supplemental Safety and Health
METHYL ETHYL KETOXIME GIVEN OFF DURING CURE(MFG).

Chemical Properties

Boiling Pt:B.P. Text:258F/125C
Vapor Pres:15@77F/25C
Vapor Density:0.2
Spec Gravity:1.17
Evaporation Rate & Reference:1.6:NBUOAC=1
Solubility in Water:NEGLIGIBLE
Appearance and Odor:THICK,WHITE,LIQUID,SOLVENT ODOR.
Percent Volatiles by Volume:47%

Stability

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS.
Stability Condition to Avoid:AVOID OPEN FLAMES&IGNITION SOURCES.
Hazardous Decomposition Products:SIO*2,CO*2,CO,TIO*2,HYDROCARBONS.
Conditions to Avoid Polymerization:WILL NOT OCCUR(MFG)

Disposal

Waste Disposal Methods:DISPOSE OF IAW LOCAL,STATE AND FEDERAL
REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.